Filter
Top Products
30
Configuring Cisco Access Routers and the NME-WAE Network Module for ACNS Deployments
OL-13140-02
show diag
show diag
To display hardware and diagnostic information for a networking device, a line card, a processor, a jacket
card, a chassis, or a network module, use the show diag command in privileged EXEC configuration
mode.
show diag [slot]
Syntax Description
Defaults None
Privileged EXEC
Command History
slot (Optional) Slot number of the interface. If a slot number is not specified,
diagnostic information for all slots is displayed.
Release Modification
11.1CA This command was introduced.
11.2 This command was integrated into IOS Release 11.2.
11.2P This command output was modified for the PA-12E/2FE port adapter, PA-E3
port adapter, and PA-T3 port adapter.
11.2GS This command was implemented on the 12000 series Gigabit Switch Routers
(GSRs).
11.3 XA This command was integrated in IOS Release 11.3 XA.
12.0 This command was implemented on the AS5300.
12.0(5)XQ This command was implemented on the 1750 router.
12.0(7)T This command was integrated into IOS Release 12.0(7)T.
12.1(9)EX This command was introduced on the 7300 series routers, and the slot argument
and chassis keyword were added.
12.1(10)EX This command was enhanced to display information about Field-Programmable
Gate Array (FPGA) image versions on installed NSEs and line cards on 7304
routers.
12.2(11)YZ Support was added for the 7300-CC-PA.
12.2(8)T This command was implemented for AIC and WIC cards on the 2600 series
routers and the 3600 series routers.
12.2(13)T This command was implemented for the AIM-VPN/EPII and AIM-VPN/HPII
cards on the 2691, 3660, 3725, and 3745 routers.
12.2(15)ZJ 2611XM, 2620XM, 2621XM, 2650XM, and 2651XM routers.
12.2(18)S This command was integrated into IOS Release 12.2(18)S and implemented on
the 7304 router.
12.3(4)T Support for the AIM-VPN/BPII card on the 2600XM series was integrated into
IOS Release 12.3(4)T.
12.2(20)S2 This command was integrated into IOS Release 12.2(20)S2 and the
subslot slot/subslot keyword and arguments were added to support SPAs on the
7304 router.