Filter
Top Products
28
Configuring Cisco Access Routers and the NME-WAE Network Module for ACNS Deployments
OL-13140-02
show controllers integrated-service-engine
show controllers integrated-service-engine
To display controller information for integrated-service-engine (ISE) network modules, use the show
controllers integrated-service-engine command in privileged EXEC mode.
show controllers integrated-service-engine slot/unit
Syntax Description
Defaults None
Command Modes Privileged EXEC
Command History
Examples Table 4 describes the fields shown in the command output.
slot Slot number of the network module in the router chassis.
/unit Number of the daughter card on the network module. For ISE network
modules, always use 0. The slash mark (/) is required between the slot
argument and the unit argument.
Release Modification
12.4(9)T This command was introduced for ISE network modules.
Table 4 show controllers integrated-service-engine Field Descriptions
Field Description
Hardware Description of the chip being used.
IDB, FASTSEND Address in router memory of the interface descriptor block (IDB)
and the fastsend routine.
INSTANCE Device-specific data stored in router memory that lists the
memory locations and current indexes of receive (Rx) and
transmit (Tx) rings in the router I/O memory.
CONTROL AND STATUS
REGISTERS (CSR)
Control and status registers that are physically located on the chip
itself and that are accessed by the CPU over the protocol control
information (PCI) bus.
PHY REGISTERS Contents of the physical layer (PHY) registers. A PHY module is
a device that interfaces to the physical Ethernet line and that is
located between the chip and the physical line.
HARDWARE STATISTICS Receive (Rx) and transmit (Tx) traffic statistics collected by the
chip.
INTERRUPT STATISTICS Transmit (Tx), Receive (Rx), control, software, and flow control
interrupt statistics collected by the chip.