Filter
Top Products
23
Configuring Cisco Access Routers and the NME-WAE Network Module for ACNS Deployments
OL-13140-02
service-module integrated-service-engine shutdown
service-module integrated-service-engine shutdown
To gracefully shut down an integrated-service-engine (ISE) network module, use the service-module
integrated-service-engine shutdown command in privileged EXEC mode.
service-module integrated-service-engine slot/unit shutdown
Syntax Description
Defaults None
Command Modes Privileged EXEC
Command History
Usage Guidelines At the confirmation prompt, press Enter to confirm the action or n to cancel.
The service-module integrated-service-engine shutdown command shuts down the operating system
of the specified integrated-service-engine network module in an orderly fashion to protect the hard drive.
When the operating system has been shut down, the module can be removed from the router, if necessary.
Examples The following example gracefully shuts down the ISE network module in slot 1:
Router# service-module integrated-service-engine 1/0 shutdown
Shutdown is used for Online removal of Service Module.
Do you want to proceed with shutdown?[confirm]
Use service module reset command to recover from shutdown.
Related Commands
slot Slot number of the network module in the router chassis.
/unit Number of the daughter card on the network module. For ISE network
modules, always use 0. The slash mark (/) is required between the slot
argument and the unit argument.
Release Modification
12.4(9)T This command was introduced for ISE network modules.
Command Description
interface integrated-service-engine Configures an interface for ISE network modules and enters
interface configuration mode.
service-module
integrated-service-engine reload
Performs a graceful shutdown and reboot of an ISE network
module ACNS operating system.
service-module
integrated-service-engine reset
Resets the hardware on ISE network modules.