Filter
Top Products
18
Configuring Cisco Access Routers and the NME-WAE Network Module for ACNS Deployments
OL-13140-02
service-module integrated-service-engine reload
service-module integrated-service-engine reload
To perform a graceful shutdown and reboot of the integrated-service-engine (ISE) network module
ACNS operating system, use the service-module integrated-service-engine reload command in
privileged EXEC mode.
service-module integrated-service-engine slot/unit reload
Syntax Description
Defaults None
Command Modes Privileged EXEC
Command History
Usage Guidelines At the confirmation prompt, press Enter to confirm the action or n to cancel.
Examples The following example gracefully shuts down and reboots the ISE network module ACNS operating
system in slot 1:
Router# service-module integrated-service-engine 1/0 reload
Do you want to proceed with reload?[confirm]
Related Commands
slot Slot number of the network module in the router chassis.
/unit Number of the daughter card on the network module. For ISE network
modules, always use 0. The slash mark (/) is required between the slot
argument and the unit argument.
Release Modification
12.4(9)T This command was introduced for ISE network modules.
Command Description
interface integrated-service-engine Configures an interface for ISE network modules and enters
interface configuration mode.
service-module
integrated-service-engine reset
Resets the hardware on ISE network modules.
service-module
integrated-service-engine
shutdown
Gracefully shuts down ISE network modules.
show diag Displays controller information for ISE network modules.
show interfaces
integrated-service-engine
Displays basic interface configuration information for ISE
network modules.