Filter
Top Products
26
Configuring Cisco Access Routers and the NME-WAE Network Module for ACNS Deployments
OL-13140-02
service-module integrated-service-engine status
service-module integrated-service-engine status
To display configuration information related to software on the integrated-service-engine (ISE) side of
a network module, use the service-module integrated-service-engine status command in privileged
EXEC mode.
service-module integrated-service-engine slot/unit status
Syntax Description
Defaults None
Command Modes Privileged EXEC
Command History
Usage Guidelines Use the service-module integrated-service-engine status command to perform the following tasks:
• Display the ISE network module software release version
• Check the ISE network module status (steady or down)
Examples The following example displays information for an ISE network module that is installed in slot 1 of an
access router:
Router# service-module integrated-service-engine 1/0 status
Service Module is Cisco Integrated-Service-Engine1/0
Service Module supports session via TTY line 66
Service Module is in Steady state
Getting status from the Service Module, please wait..
Cisco Application and Content Networking System Software 5.5.7 (b17 Apr 27 2007 08:56:37)
Restarted at Sun Apr 1 15:32:38 2007
The following example displays information for an ISE network module that is not running:
Router# service-module integrated-service-engine 1/0 status
Service Module is Cisco Integrated-Service-Engine1/0
Service Module supports session via TTY line 258
Service Module is trying to recover from reset/shutdown
Service Module status is not available
slot Slot number of the network module in the router chassis.
/unit Number of the daughter card on the network module. For ISE network
modules, always use 0. The slash mark (/) is required between the slot
argument and the unit argument.
Release Modification
12.4(9)T This command was introduced for ISE network modules.