Filter
Top Products
34
Configuring Cisco Access Routers and the NME-WAE Network Module for ACNS Deployments
OL-13140-02
show interfaces integrated-service-engine
rxload Receive load on the interface as a fraction of 255 (255/255 is
completely saturated), calculated as an exponential average over
5 minutes.
Encapsulation Encapsulation method that is assigned to the interface, ARPA in
this case.
loopback Indicates whether loopback is set.
Keepalive Indicates whether keepalives are set and the interval between
keepalives if they have been set.
Full-duplex Indicates either full-duplex or half-duplex mode and other link
configuration details.
ARP type Timeout Type of Address Resolution Protocol (ARP) assigned and length
of timeout.
Last input Number of hours, minutes, and seconds since the last packet was
successfully received by the interface and processed locally on
the router. This field is useful for detecting when an interface
failed.
This field is not updated by fast-switched traffic.
output Number of hours, minutes, and seconds since the last packet was
successfully transmitted by the interface. This field is useful for
detecting when an interface failed.
output hang Number of hours, minutes, and seconds (or never) since the
interface was last reset because a transmission took too long.
When the number of hours in any of the “last” fields exceeds
24 hours, the number of days and hours is printed. If that field
overflows, asterisks are printed.
Last clearing Elapsed time since the counters that measure cumulative statistics
(such as number of bytes transmitted and received) shown in this
report were last reset to zero. Variables that may affect routing
(for example, load and reliability) are not cleared when the
counters are cleared.
Asterisks (***) indicate that the elapsed time is too large to be
displayed.
Input queue Number of packets in the input queue. A slash separates the
following values that indicate the maximum size of the queue, the
number of packets dropped because of a full queue, and the
number of times that queued packets have been discarded.
Total output drops Number of packets in the output queue that have been dropped
because of a full queue.
Queueing strategy Queuing strategy applied to the interface, which is configurable
under the interface. The default is FIFO.
Output queue Number of packets in the output queue. A slash separates the
following values that indicate the maximum size of the queue and
the number of packets dropped because of a full queue.
Table 6 show interfaces integrated-service-engine Field Descriptions (continued)
Field Description