Filter
Top Products
21
Configuring Cisco Access Routers and the NME-WAE Network Module for ACNS Deployments
OL-13140-02
service-module integrated-service-engine session
service-module integrated-service-engine session
To begin a configuration session with an integrated-service-engine (ISE) network module through a
console connection, use the service-module integrated-service-engine session command in privileged
EXEC mode.
service-module integrated-service-engine slot/unit session [clear]
Syntax Description
Defaults None
Command Modes Privileged EXEC
Command History
Usage Guidelines Only one session at a time is allowed into the network module from the internal ISE
network-module-side interface.
After starting a session, access the ISE console in a user-level shell. To access the privileged EXEC
command shell, where most commands are available, use the enable command.
After you finish the ISE configuration and exit the ISE console session, use this command with the clear
keyword to clear the session. At the confirmation prompt, press Enter to confirm the action or n to
cancel.
Examples The following example shows an ISE session being opened for an ISE network module in slot 2:
Router# service-module integrated-service-engine 2/0 session
Trying 10.10.10.1, 2066 ... Open
Cisco Content Engine Console
Username:
slot Slot number of the network module in the router chassis.
/unit Number of the daughter card on the network module. For ISE network
modules, always use 0. The slash mark (/) is required between the slot
argument and the unit argument.
clear (Optional) Clears the ISE configuration session.
Release Modification
12.4(9)T This command was introduced for ISE network modules.