Filter
Top Products
17
Configuring Cisco Access Routers and the NME-WAE Network Module for ACNS Deployments
OL-13140-02
service-module integrated-service-engine default-boot
service-module integrated-service-engine default-boot
To configure the integrated-service-engine (ISE) network module to use the default BIOS and
bootloader, use the service-module integrated-service-engine default-boot command in privileged
EXEC mode.
service-module integrated-service-engine slot/unit default-boot
Syntax Description
Defaults None
Command Modes Privileged EXEC
Command History
Examples After a downtime event or failed upgrade, use the service-module integrated-service-engine slot/unit
default-boot command to configure the network module to use the primary BIOS and primary
bootloader to perform startup routines.
The following is sample output from the integrated-service-engine slot/unit default-boot command for
a port adapter in chassis slot 2 on a Cisco router:
Router# service-module integrated-service-engine 2/0 default-boot
clear Clear Default Boot
set Set Default Boot
Router# service-module integrated-service-engine 2/0 default-boot clear
Router# service-module integrated-service-engine 2/0 default-boot set
slot Slot number of the network module in the router chassis.
unit Number of the daughter card on the network module. For ISE network
modules, always use 0.
Release Modification
12.4(9)T This command was introduced for the ISE network module.