Filter
Top Products
9
Configuring Cisco Access Routers and the NME-WAE Network Module for ACNS Deployments
OL-13140-02
Setting Up Cisco WAE Network Modules and Opening a Session
Use the following commands from the Network Module Interface
4. Log in to the network module.
5. Perform configuration or other procedures by using the ACNS CLI.
6. Press Control-Shift-6 x.
Use the following command from the host router CLI:
7. service-module integrated-service-engine slot/0 session clear
Detailed Steps
To open a network module session, perform the following steps:
Procedure Command
Step 1
From the host router CLI, enter privileged EXEC mode on
the host router. Enter your password if prompted.
enable
Example:
Router> enable
Step 2
Display the status of the specified module so that you can
ensure that the module is running (that is, in the steady
state). For details, see the service-module
integrated-service-engine status command.
If the module is not running, start it with one of the startup
commands listed in the “Shutting Down and Starting Up
Cisco WAE Network Modules” section on page 11.
service-module integrated-service-engine slot/0
status
Example:
Router# service-module
integrated-service-engine 2/0 status
Step 3
Begin a service module session on the specified module.
Perform one of the following actions:
• To interrupt the auto-boot sequence and access the
bootloader, quickly type ***.
• To start a configuration session, press Enter.
To use telnet to access the network module, use the second
form of the command.
service-module integrated-service-engine slot/0
session
or
telnet module-ip-address port
Example:
Router# service-module
integrated-service-engine 1/0 session
Trying 10.10.10.1, 2066 ... Open
or
Router# telnet 10.10.10.1 2066
Step 4
From the network module interface, log in to the network
module. The default username is admin and the default
password is default.
Cisco Content Engine Console
Username: admin
Password:
System Initialization Finished.
SE-Module#