Filter
Top Products
ALL MODELS
ATTACHING THE HANDWHEEL
1. From loose parts bag find one (1) pan head screw
10-32 x 2 and one (1) hex nut. Install the hand-
wheel. Reach inside the base to the back side of
the bevel mechanism and put the nut in place.
Hold the nut in place with a finger. Install the
screw through the center of the handwheel and
tighten with a phillips screwdriver.
2. Hold the handle and pull the red release button
with your finger to close the handle.
1
7
_T _-_
( i¸ '
MOUNTING THE MOTOR
1. Find the following parts:
ITEM DESCRIPTION QTY.
A Motor ............................... 1
B Spacer(I/40.D. x %6) ................... 3
C Flanged Locknut #10-32 ................. 4
D Wing Nut %6-18 ....................... 1
E Motor Pulleyw/Set Screw
(Model 113.248320, 113.248440,
113.248510) ........................ 1
F Belt Tension Stud ..................... 1
G Motor Pulleyw/Set Screw
(Model 113.248210) .................. 1
H Poly "V" Belt ........................ 1
I Key 3/%Sq. x 1%6
(Model 113.248320, 1!3.248440,
113.248510) ........................ 1
F
*NOT SHOWN TO SCALE
2. Place the three (3) spacers onto the three motor
studs as shown. Pay attention to where the oil plug is
located. No spacer goes on the fourth motor stud.
MODEL 113.248210 ONLY
3. Install the motor pulley onto the motor shaft with the
set screw boss toward the motor. Position the outer
face of the pulley 2 inches from the end shield of the
motor and tighten the set screw against the flat side
of the motor shaft using a 1/8-inch hex "E' wrench.
1
1
OIL PLUG
r
- OIL PLUG
17