Filter
Top Products
ADJUSTING FRONT TABLE
1. Adjust the front table so it is the same height as the
rear table as follows:
a, Lay a straight edge across front table to rear
table.
b. Gentlytap the fronttable down until it is in line with
the rear table,
c. Tighten the Phillips head self tapping screw once
the front table is in the correct position.
d. If necessary adjust the two (2) oval point set
screws (see Step 3) as needed to help line up the
table.
e. Both the left and right sides of the front table
should be adjusted simultaneously.
TABLE LEVELING
SETSCREWS
2, To keep the miter gage grooves in line, use a flat
blade screwdriver against the head ofone of the low
head capscrews in the miter gage groove to force
the table alignment key firmly forward intothe notch
in the front table.
3. While holding the alignment key into the notch,
tighten theother capscrew. Removethe screwdriver
and tighten the remaining screw. Check that the
miter gage grooves line up,
4. Check the operation of springs and tabs by remov-
ing the front table and reinstalling. Removethetable
by lifting up on two spring tabs under front edge of
the table until springs are free, then pulling forward.
33