Craftsman 113.248510 Saw User Manual


 
MODELS 113.248320,
113.248440, and
113.248510
4. Locate the correct motor pulley (Model 113.248210
has a "one-step" pulley). Placethe shaft key intothe
groove on the motor shaft. Align the groove in the
pulley with the shaft key and install the motor pulley
on the motor shaft with the setscrew boss toward the
motor.
ALL MODELS
5. Place the Poly "V" belt into the motor mount as
shown on the underside of the band saw.
6. Look atthe motor mount and find the slot that is nar-
rower than the other three. When mounting the
motor, the motor stud without a spacer goes into this
slot.
MOTOR MOUNT
NARROW
SLOT
7. Carefully position the motor sothat the poly"V" belt
is around the motor pulley and the four motor studs
align with the slots in the motor mount.
8. Push motor studs through and install the flanged
lock nuts to the three (3) motor studs with spacers.
Start the flanged nuts by hand only at this time.
MOTOR MOUNT
9. Install the threaded stud through the hole in the
lower leg ofthe motor mount and over the motor stud
as shown.
MOTOR MOUNT
THREADED STUD
18