Filter
Top Products
Unpacking and Checking Contents
Tools Needed
Phillips Screwdriver
Medium Screwdriver
Small Screwdriver
Combination Wrenches
3!8 ino,7116 In,, 112 Ino,9/16 In.
Hex "L" Wrenches
3/16 In., 1/8 In,
Utility Knife
Tape Rule
Unpacking
1 Separate saw and all parts from packing materials and
check each one with the illustration and the "List of
Loose Parts" to make certain all items are accounted
for, before discarding any packing material
Combination Square must be true. Check it's
accuracy as shown below.
Draw light line on
board along edge
I i
LI
Select the straight edge of
314" thick board. This edge
must be perfectly straight.
NOTE: The square and
straight edge are used to
align the saw, They must
be accurate if the saw is
to be aligned properly,
\
Should be no gap or overlap here when square
isflipped over in dotted position,
WARNING: If any parts are missing, do not attempt
to assemble the table saw, plug in the power cord
or turn the switch on until the missing parts are
obtained and are installed correctly.
WARNING: The saw is heavy° To avoid back injury,
get help to lift the saw. Hold the saw close to your
body. Bend your knees so you can lift with your
legs, not your back.
WARNING: For your own safety, never connect
plug to power source outlet until all assembly
steps are complete, and you have read and under-
stand the safety and operating instructions.
_., Combination
Square
,_',- ',i '.;: :'._ '.I _,t
Framing Square
NOTE: Before beginning assembly:
o Check that all parts are included If you are missing any
part, do not assemble the saw Contact your Sears Ser-
vice Center to get the missing part
o Sometimes small parts can get lost in packaging mate*
riat Do not throw away any packaging until saw is put
together Check packaging for missing parts before
contacting Sears
o A complete parts list (Repair Parts) is at the end of the
manual Use this list to identify the part number of the
missing part
10