Filter
Top Products
Getting to Know Your Table Saw ......
8 Sawblade 6 Blade Guard
5 Miter Gauge
4 RipFence
9 Exacti-Cut
3 Tilt
Handwheel
7 Table Insert
2 Elevation
Handwheel
Switch
1, On-Off Switch.
I CAUTtON: Before turning switch "ON", make sure
the blade guard is correctly installed and operat-
ing properly.
The On-Off Switch has a locking feature_ This feature is
intended to help prevent unauthorized and possible haz-
ardous use by children and others
A Remove key from bag labeled "Miscellaneous" and
insert into switch.
B To turn saw ON, stand to either side of the bJade,
never in line with it, insert finger under switch lever
and pull end of lever out
After turning switch ON, always allow the blade to
come up to full speed before cutting. Do not cycle
the motor switch on and off rapidly, as this may
cause the sawblade to loosen. In the event this
should ever occur, allow the sawbIade to come to a
complete stop and retighten the arbor nut normally,
not excessively Never leave the saw while the
power is "ON"
CTo turn saw OFF, PUSH lever in Never leave the
saw until the cutting too} has come to a complete
stop
DTo lock switch in OFF position, hold switch IN with
one hand, REMOVE key with other hand
WARNING: For your own safety, lower blade or
other cutting tool below table surface. (if blade is
tilted, return it to vertical, 90 °, position.) Always
lock the switch "OFF". When saw is not in use,
remove key and keep it in a safe place. Also, in the
event of a power failure (all of your lights go out)
turn switch off, lock it and remove the key. This
will prevent the saw from starting up again when
the power comes back on.
21
©