Filter
Top Products
Basic Saw Operations (continued)-
Ripping(continued)
Once the trailing end is on the table: Push Stick
When "width of rip" is 2" or wider, use the push stick to
finish pushing the work all the way past the blade
When "width of rip" is narrower than 2" the push stick Guard
cannot be used because the guard will interfere_ use the \
auxiliary fence and push block.,
\
Attach auxiliary fence to rip fence with two "C" clamps
Auxiliary
fence
Feed the workpiece by hand along the auxiliary fence
until the end is approximately 1" past the front edge of the
table, Continue to feed using the push block.
Hold the workpiece in position and install the push block
by sliding it on top of the auxiliary fence (this may raise
guard)
Push Block
Workpiece
32