Filter
Top Products
Adjustments (continued) ..........
Adjusting the Spring
1 Loosen the screws
2. Move spring slightly toward front of fence Tighten
screws
If the fence does not slide easily along the bars, the pres-
sure of the spring can be reduced.
1 Loosen the screws
2 Move spring slightly toward rear of fence Tighten
screws
Spring
Screws
Slide Spring To
Adjust Pressure
i .... , i, i,,11,, r,_tl ,, i,i1,1 ....
Rip Fence Alignment Adjustment
WARNING: A misaligned rip fence can cause kick-
backs and jams_ To avoid injury, follow these
instructions until the fence is properly aligned,
The rip fence must be parallel with the sawbtade and
miter gauge grooves Move fence until it is along side of
groove Do not lock it. It should be parallel to groove tf it
is not:
1. Loosen the hex head screws
2. Hold fence head tightly against bar Move end of fence
so that it is parallel with groove
3 Alternately tighten the screws
4 Recheck alignment_
5. Repeat steps, as needed.
Fence Head
Adjusting Rip Scale Indicator
1 Turn elevation handwheel clockwise until blade is up
as high as it wilt go
IMPORTANT: Blade must be square (90°) to table, in
order to align rip fence
2oUsing a rule, position fence on right side of sawbtade 2
inches from the side of the teeth, tighten lock handle
3 Loosen screw holding the indicator, adjust so that it
points to "2" on the rip scale, tighten screw.
NOTE: If you cannot adjust indicator so that it points to
"2", loosen the screws holding the front guide bar and
move the guide bar.
\
Lock Handle
38