Filter
Top Products
Mounting Your Saw
1 From the bag labeled "Base" remove the following
hardware:
*4 Hex Head Screws, 5/16-18 x 1-I/8" Long
*4 Hex Nuts, 5/16-18
*4 Lockwashers, 5/16" External Type
*8 Fiat Washers, tl/32 x 11/16 x 1/16
items marked with asterisk (*) are shown actual size
2 Place the saw upside down onto a smooth piece of
cardboard or heavy paper, on the floor, so the saw is
resting on the table top
WARNING: The saw is heavy. To avoid back injury,
get help to lift the saw. Hold the saw close to your
body. Bend your knees so you can lift with your
5t16-18 x 1-1/8 In 5/16-18
Hex Head Screw Hex Nut
5/16 In External
Lockwasher 11/32 LD.
Flat Washer
3. Place legs on saw so that holes in saw base and leg
set line up and trim label is facing front. Legs will over-
hang base in rear
4. Install screw, washers, lockwasher and nut as shown
5 Tighten all leg assembly and mounting hardware at
this time
Cardb,
Hex
Flat Washer
End Stiffener
Leg Set
Flat Washer
Hex Head Screw
Saw Base
NOTE: For clarity, later manual illustrations may not
show leg set attached
Bench Mounting
If you do net use the legset and prefer to mount the saw
on a bench, make sure that there is an opening in the top
of the bench the same size as the opening in the bottom
of the saw so that the sawdust can drop through Recom-
mended working height is 33 to 37 inches from the top of
the saw table to the floor
14-3/4
12
1/2--,-- _l
Front of Saw
NOTE: All dimensions in inches
13