Filter
Top Products
Installing Blade Guard
1. From the bag Iabeled "Guard" remove the following
hardware:
*2 Truss Head Screws, t/4-20 x 5/8" Long
*2 Socket Head Set Screws, 1/4-20 x 7/8" Long
*4 Fiat washers, 17/64 x 9/16 x 3/64
*2 Hex Nuts 1/4_20
*4 Lockwashers, 1/4 ExternalType
*2 Wing Nuts, 1/4-20
*2 Square Nuts, 1/4-20
1 Spreader Support
1 Spreader Bracket
1 Spreader Clamp
From among the loose parts find the following:
1 Blade Guard
Items marked with asterisk (*) are shown actual size
1/4-20 7/8
X
Socket Head
8 In Set Screw
Truss Head Screw
Q 1/4-20 17164I°D.
114-20Hex Nut Square Nut Flat Washer
©
1/4 In,, External
Lockwasher
1/4-20 Wing Nut
Spreader Support
Spreader Bracket
2, Make sure the blade is all the way up and square with
table,
3, Position spreader support on rod until it is even with
the end of the rod.
\
Blade Square
With Table
Even With Rod
= i ...........
4 Assemble the 7/8 inch long set screws, nuts, lock-
washers and washers to the spreader support bracket
and slip the nuts into the slot in the spreader support,
5 Finger tighten only the hex nuts
NOTE: Be sure to put the socket head set screw through
the slot shaped holes in the spreader bracket (see itlus-
tration)_ This allows the guard and spreader to be Iined
up with the blade Be sure the socket end of the set
screw is at the hex nut end of the assembly,
Holes Up
Round Hole
On Side
- Leckwasher
ex Nut --='_
19