Filter
Top Products
Assembly (continued) .....
Checking Table Insert
The table insert must be flush with the surface of the saw
table to keep the workpiece from hanging up or binding
with the sawbtade as the workpiece is cut by the saw-
blade,
1 Lower sawblade beneath the table insert and check to
be sure the screw fastening the insert in place is snug
2 Use a straight edge to check near each of the eight
leveling tab positions to determine if the insert is flush
with the surface of the saw table at all eight leveling
tab positions
3. tf insert is not flush with table surface, loosen insert
fastening screw and pull insert forward to lift from saw
table
4, Bend with pliers or tap with a hammer, as required, to
make the insert flush with the table top,
Leveling
Tab
Edge
. /--
\
\
18