Filter
Top Products
Note:Therightsideof sawisonyourrightwhen
facingthesaw,asif youwereinnormal
operatingposition.
INSTALLINGTHEREARRAIL
See Figures 12- 14.
,4_ WARNING: Front and rear rails must be
installed and carefully aligned to reduce the risk
of kickback. Kickback can result in serious injury.
• From the carton, remove the rear rail pieces and
the following hardware:
6 square head bolts (5/16-18 x 1 in.)
6 fiat washers (5/16 in.)
6 hex nuts (5/16-18)
Rear rail connector
Right and left end caps for rear rail
2 screws (#8-32 x 1/2 in.)
Note: Remaining hardware from this hardware bag is
used for installing the front rail and end caps.
• At the back of the table, put the square head bolts
in the holes in the edge of the saw table and the
outer holes in each extension table so the bolt
heads extend outward 1/2 in.
• Under the table, loosely attach washers and hex
nuts onto bolts. Slide the slot on the rear rail over
the bolts. Adjust each bolt to fit the rail closely to
the table.
• Position right rail (longest piece) so that right hand
edge extends 2-1/2 inches beyond table extension.
• Push right rail against table and tighten each nut
with a 12 mm wrench, tf rail jams and does not
slide easily over bolts, re-align table extensions.
• Put the end caps on rail ends. Insert the screws
and tighten with a phillips head screwdriver.
TABLE
8LOT EXTEN810N
REAR RAIL
8QUARE
WA8HER
TABLE
REARRAIL
REARRAIL
CONNECTOR
Fig. 13
2-1/2in,
ENDCAP
REARRAIL
8QUARE HEXNUT
HEADBOLT8 FLAT
WA8HER Fig. 12
21
REAROF8AW
8CREW
Fig. 14
rRRFTSMRN°TABLE SAW315.228390