Filter
Top Products
ALIGNINGTHE RIVING KNIFE WITH THE
BLADE
See Figures 26 - 28.
_i WARNING: Make sure the switch is off, the
switch key is removed, and your saw is
unplugged. Failure to do so could result in
accidental starting, causing serious personal
injury.
The riving knife must be aligned with and centered
over the blade.
_i WARNING: It is important to install and adjust
the riving knife correctly. Poor alignment could
cause kickback and throw the workpiece at the
operator.
• Raise the blade guard.
• Place a framing square or straightedge beside the
blade on the left. See Figure 26.
• Loosen the front screw on the riving knife with a
5 mm hex key. See Figure 27.
• Center the riving knife over the blade. See Figure
28.
• Securely tighten the screw with a 5 mm hex key.
RIVINGKNIFE
BLADE
SAW
TABLE
FRAMINGSQUARE Fig. 26
BLADE GUARD
RIVINGKNIFE
BLADE
RIVINGKNIFE
'/
FRAMING
SQUARE
BLADE_
J
THROAT
PLATE
TOPVIEWOF SAWWITHRIVING
KNIFESHOWNCENTEREDOVERBLADE
/
Fig. 27
Fig. 28
rRRFTSMRN*TABLE SAW315.228390 26