Filter
Top Products
– 41 –
12.3 Check after piping
q The heating pipe is not sunk significantly due to a clamp, etc.
w The bent section has an adequately large bending radius.
e Electrical connections are exact.
r The end of heater wire (bus) is not short-circuited (it must never be short-circuited).
t All parts of the connection kit (sealing connector), etc. have been used.
y Screws of the connection kit (sealing connector), etc. have been tightened completely.
12.4 Clamp support
Clamps for conduit should be used. For heating pipe profile of the tube trace, refer to 12.5.
The heating pipe should be clamped so that it will be sunk significantly.
GoodNo good
Fig. 12-8