Filter
Top Products
Setup Screens
Setup Screens
Use the Setup screens to set control
parameters for the motor. See
Screen Navigation and Editing, page 9 ,for
information on how to make selections and enter
data.
Inactive fiel
ds are grayed-out on a screen.
Information displayed on the Setup screens
corresponds to the Modbus Registers. See
Appendix A - Modbus Variable Map, page 34.
NOTE: Before setting up profiles on Setup Screens
1–4, do the initial setup on Setup Screens 5–15.
Screens 5–15 establish the configuration for your
system and affect the displayed data.
SetupScreen1
Use this s
creen to set the operating mode for a
selecte
d pump and profile.
Figure 14 Setup Screen 1
SetupScreen1Key
Enter the scre
en.
Pump selection — See Step 1.
Profile selection — See Step 2.
Pressure mode or Flow mode — See
Step 3
Setting for Back Pressure Regulator —
SeeStep4.
Press to accept the selections.
This softkey is disabled by default, and
only appears if the “Profile Lock” box is
checked on Setup Screen 15, page 29.
Press to activate the profile just edited.
Exit the screen.
16 3A2527D