Filter
Top Products
Operation
Screen Naviga
tion and Editing
Refer to this section if you have questions about
screen navigation or about how to enter information
and make selections.
All Screens
1. Use
to move between screens.
2. Press
to enter a screen. The first data field
on the screen will highlight.
3. Use
to highlight the data you wish to
change.
4. Press
to edit.
Drop Down Field
1. Use
to highlight the correct choice from
the dropdown menu.
2. Press
to select.
3. Press
to cancel.
Number Field
1. The first digit will be highlighted. Use
to change the number.
2. Press
to move to the next digit.
3. When all digits are correct, press
again to
accept.
4. Press
to cancel.
Check Box Field
A check box field is used to enable or disable features
in the software.
1. Press
to toggle between andanempty
box.
2. The feature is enabled if a
is in the box.
Reset Field
The reset field is used for totalizers. Press
to
reset the field to zero.
When all data is correct, press
to exit the screen.
Then use
to move to a new screen, or
to move between Setup screens and Run screens.
Initial Se
tup
NOTE: Before creating the pump profiles in Setup
Screens 1 through 4, you must set up the system
parameters in Setup Screens 5 through 15, as
follows.
1. Press
to enter the Setup screens. Setup
Screen 1 will appear.
2. Scroll to Setup Screen 5.
3. See Setup Screen 5, page 22,andselectthe
lower used in your system.
4. Continue setting the system parameters
on Setup Screen 6, page 23 through
Setup Screen 15, page 29.
5. Scroll to Setup Screen 1. Establish
the profiles for each pump. See
Setup Screen 1, page 16 through
SetupScreen4,page20.
3A2527D 9