Filter
Top Products
Model G0757Z (Mfd. Since 02/15)
-29-
Table Rotation
The table rotates 45° left or right (see Figure 22).
Figure 22. Table rotated 45° to the right.
Hex Nuts
(2 of 4)
Tool Needed Qty
Open-End Wrench 19mm .................................. 1
To rotate table:
1. DISCONNECT MACHINE FROM POWER!
2. Remove as many items from table as pos-
sible. This makes rotating table easier.
3. Loosen four hex nuts that secure table to
knee (see Figure 22).
Note: There are two additional hex nuts
behind table.
4. Using angle scale on table knee as a guide,
rotate table to desired position.
5. Retighten four hex nuts that secure table to
knee before resuming operation.
Head Tilt
When positioning head back to 0° after
tilting it, you will need to tram it to ensure
spindle is precisely perpendicular to table
to ensure proper milling accuracy. Refer to
Tramming Spindle section on Page 58 for
detailed instructions.
Table
Knee
Tools Needed Qty
Open-End Wrench 19mm .................................. 1
Open-End Wrench 24mm .................................. 1
To tilt head:
1. DISCONNECT MACHINE FROM POWER!
2. Loosen three hex nuts (one on each side of
head and one underneath) that secure head
to ram (see Figure 23).
Figure 23. Head tilting controls.
Hex Nut
(1 of 3)
Scale
Tilting
Bolt
3. With assistance from another person to sup-
port head, turn tilting bolt until head is in
desired position.
Note: Use angle scale shown in Figure 23 as
a guide for setting tilt angle.
4. Retighten hex nuts that secure head to ram
before resuming operation.
The head tilts 90° left or right at the end of the
ram.