Filter
Top Products
Model G0757Z (Mfd. Since 02/15)
-31-
Installing /Removing
To o li n g
Vertical Spindle
Tooling is held in the vertical spindle by a combi-
nation of the R-8 taper, a pin inside the spindle,
and a
7
⁄16"-20 drawbar.
Cutting tools are sharp and can easily
cause laceration injuries. Use heavy leather
gloves or shop rags to protect your hands
when handling cutting tools.
1. DISCONNECT MACHINE FROM POWER!
2. Clean any debris or surface substances from
inside spindle taper and mating surface of
tooling.
Note: Debris or oily substances can prevent
tooling and spindle from properly mating.
This condition can cause excessive vibration,
poor cutting results, or tool/workpiece dam-
age.
3. Align tooling keyway with pin inside spindle
taper, then firmly push tooling into spindle to
seat it.
Installing Vertical Spindle Tooling
The Model G0757Z includes the following vertical
spindle tools (see Figure 28):
A. B16 Drill Chuck w/R-8–B16 Arbor. Refer to
Arbor/Chuck Assembly on Page 21.
B. R-8–MT#3 Spindle Sleeve. Used for MT#3
tools and will accommodate tools with a tang.
It also has a drift key slot for tool removal.
C. MT#3–MT#2 Spindle Sleeve. Used for MT#2
tools and will accommodate tools with a tang.
It also has a drift key slot for tool removal.
D. R-8–1" End Mill Arbor. Arbor accepts 1"
bore mill cutters.
E. Drift Key: Use for tool removal.
Figure 26. Vertical spindle tools included with
model G0757Z.
A
B
C
Drift Key Slot
D
E
Tang
Tools Needed Qty
Open-End Wrench 19mm .................................. 1
Brass Hammer .................................................. 1