Honeywell NXL Welding System User Manual


 
Control Keypad 75(96)
7
Software info submenu (S6.8.3)
The following information can be found under the Software info submenu (S6.8.3):
Page Content
I6.8.3.1 Software package
I6.8.3.2 System software version
I6.8.3.3 Firmware interface
I6.8.3.4 System load
Table 7-8. Software information pages
Application information submenu (S6.8.4)
You can find the following information from the Application info submenu (S6.8.4)
Page Content
A6.8.4.1 Application
D6.8.4.1.1 Application id
D6.8.4.1.2 Version
D6.8.4.1.3 Firmware interface
Table 7-9. Application information pages
Hardware information submenu (S6.8.5)
You can find the following information from the Hardware info submenu (S6.8.5)
Page Content
I6.8.5.2 Unit voltage
I6.8.5.3 Brake chopper
Table 7-10. Hardware information pages
Connected options submenu (S6.8.6)
The Connected options submenu (S6.8.6) shows the following information on the option board
connected to the frequency converter:
Page Content
S6.8.6.1
Slot E
Option board
I6.8.6.1.1
Slot E
Option board status
I6.8.6.1.2
Slot E
Program version
S6.8.6.2
Slot D
Option board
I6.8.6.2.1
Slot D
Option board status
I6.8.6.2.2
Slot D
Program version
Table 7-11. Connected options submenu
In this submenu you find information about the option board connected to the control board (see
chapter 6.2)
You can check the status of the slot by entering the board submenu with the Menu button right and
using the Browser buttons. Push the Menu button right again to display the status of the board. The
selections are shown in Table 7-5. The keypad will also display the program version of the
respective board when you push either one of the Browser buttons.