Filter
Top Products
F-14F-14
PRECISION TIG 275
TROUBLESHOOTING & REPAIR
Observe Safety Guidelines TROUBLESHOOTING GUIDE
detailed in the beginning of this manual.
If for any reason you do not understand the test procedures or are unable to perform the test/repairs safely, con-
tact the Lincoln Electric Service Department for electrical troubleshooting assistance before you proceed.
Call 1-888-935-3877.
PROBLEMS
(SYMPTOMS)
POSSIBLE AREAS OF
MISADJUSTMENT(S)
RECOMMENDED
COURSE OF ACTION
STICK WELDING PROBLEMS
The stick electrode “blasts-off”
when touched to the work piece.
NOTE: BEFORE REPLACING A
CONTROL BOARD
If an Advanced Control Panel is
installed, remove it and replace
the Jumper in connector J-3. If
the machine functions normally,
the Advanced Process panel or
harness is defective.
1. Welding current may be too high
for the electrode size. Reduce
current control setting or use a
larger diameter electrode.
1. Perform the SCR Bridge Test.
2. The control board may be faulty.
Variable or sluggish welding arc
when welding in the Stick mode.
1. Check the work and electrode
cables for loose or poor connec-
tions.
2. The welding cables may be too
small or too long to permit the
desired current to flow.
3. The welding current may be set
too low.
1. Check the polarity switch for
excessive wear or faulty connec-
tions.
2. Check the interior heavy current
carrying leads and connections.
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
CAUTION