Filter
Top Products
LN-15
F-25 F-25
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
REPLACEMENT PROCEDURE
1. Install the new contactor using the
four screws previously removed.
2. Replace the copper bus bar and cable.
3. Install the the contactor assembly into
the case.
4. Using the 7/16” wrench mount the
contactor assembly to the divider
plate.
5. Install the two rubber mounts
previously removed.
6. Connect the two coil leads.
7. Connect all group leads previously
removed.
8. Using the 3/4” wrench replace the
welding cable and lead 567 and 567A.
9. Replace the wire drive assembly.
10. Replace the roll cage.
TROUBLESHOOTING AND REPAIR
CONTACTOR REMOVAL AND REPLACEMENT PROCEDURE (Continued)