Filter
Top Products
Operation
24
Camera operation buttons
Joystick:
When in camera mode and a camera
menu is not being displayed, this can
be used to carry out pan, tilt and zoom
operations.
AUTO PAN START: (P27)
When this button is pressed, automatic
panning is carried out between the
preset panning positions.
When some other operation is carried
out, automatic panning stops.
AUTO SEQ START: (P27)
When this button is pressed, sequential
panning is carried out between the
preset sequential positions.
When some other operation is carried
out, automatic sequential panning stops.
AUTO TOUR START: (P27)
When this button is pressed, the camera
starts moving along the path that has
been preset at the camera.
When some other operation is carried
out, automatic tour operation stops.
OPEN CAM MENU?:
This is used to display the camera
menu. You will be prompted to enter a
password in order to display the menu.
For details, refer to “Operating the
camera by changing camera menu
settings using the system controller”.
See page 25.
AUX ON:
Turns on and off an auxiliary function.
For details, refer to “Auxiliary function
operation”. See page 26.
AUTO FOCUS:
Automatically focuses the images which
are currently being monitored.
■Operating the camera from the
system controller
Press the button corresponding to the
number of the camera to be operated
(Example: 2), and then press the ENT
button.
SANYO SSP 19.2k
CAM:001 D1 CH01
Camera 2 will be selected and the channel
connected to DVR 01 will change to 2.
For details, refer to “Camera address numbers
(default value)”. See page 31.
SANYO SSP 19.2k
CAM:2
–
SANYO SSP 19.2k
CAM:002 D1 CH02
CA B
D
A Currently-selected camera address number
(CAM:002)
B Currently-connected DVR number (D1)
C Channel number of currently-connected DVR
(CH02)
D Communication protocol (SSP)/speed (19.2k)
■
Camera operations