Filter
Top Products
e-STUDIO160/200/250
PRECAUTIONS FOR STORING & HANDLING SUPPLIES
3 - 2 December 2002 TOSHIBA TEC
3.2 Checking and Cleaning of the Pressure Roller
(1) Handling precautions
Do not allow any hard object to hit or rub against the surface.
Do not stain the pressure roller surface with any oil of fingerprints, etc.
Do not allow solvents such as paint thinner to touch the pressure roller surface.
(2) Cleaning procedure
Use a cloth which should be soaked in water and then wrung strongly to clean the pressure roller surface.
3.3 Checking and Cleaning of the Cleaning Roller
(1) Handling precautions
Do not allow any hard object to hit or rub against the surface.
Do not stain the pressure roller surface with any oil of fingerprints, etc.
Do not allow solvents such as paint thinner to touch the pressure roller surface.
(2) Checking
Defective heat roller cleaning should be judged by the toner deposited on the pressure roller surface
It toner is heavily adhered on the heat roller surface, defective cleaning any occur. If this happens, replace
the cleaning roller.
Replace it preferably after about 81K copies for e-STUDIO160 series and 99K copies for e-STUDIO200/
250 series have been made.
(3) Cleaning procedure
Use a cloth which should be soaked in water and then wrung strongly to clean the cleaning roller surface.