Filter
Top Products
December 2002 TOSHIBA TEC 4 - 9 e-STUDIO160/200/250 TROUBLESHOOTING
E14 Tray 2 feeding jam
When recording paper is left on the recording paper path, remove it. If this error occurs fre-
quently, the following items should be checked.
Where was the paper stopped?
Near the registration roller
Is the 2nd feed roller sensor working? (using the test mode 04, Sensor Test, DATA No. 20
Bit 6)
1. Check if each connector between the 2nd feed roller sensor and the
PFC PWA (CN205) is disconnected.
2. Check if each connector between the PFC PWA (CN201) and the relay
PWA (CN36) is disconnected.
3. Check if each connector pin is removed or the harness is broken.
4. Check if any conductor pattern on the PFC, relay and main PWA is
open- or short-circuited.
5. Replace the 2nd feed roller sensor.
6. Replace the PFC PWA.
7. Replace the relay PWA.
8. Replace the main PWA.
Check to see if there are any foreign obstacles on the recording paper path.
Before reaching the 2nd feed roller
Is the 2nd feed roller clutch working? (using the test mode 10, Output Test, CODE 203)
YES
NO