Filter
Top Products
e-STUDIO160/200/250 TROUBLESHOOTING 4 - 70 December 2002 TOSHIBA TEC
Step
1
2
3
4
5
6
7
8
Cause/Defect area
Paper
Transfer charger
Registration roller
Pinch roller
HVPS (transfer/separation
charger/guide bias)
Measures
Reinsert paper with reverse side up or change
paper.
Change paper.
Avoid storing paper in damp place.
Clean transfer charger case.
Clean transfer charger wire.
Clean roller, or replace defective clutch-related
parts.
Re-mount or replace spring.
Adjust output from HVPS, or replace defec-
tive HVPS.
Replace process unit, laser scanner unit, or
the transfer unit.
Check items
Paper in cassette or LCF curled?
Paper in cassette or LCF damp?
Transfer charger case dirty?
Transfer charger wire dirty?
Registration roller malfunctioning?
Pinch roller spring out of place?
High-voltage output defective?
If problem persists after measures
are applied, or there is no prob-
lem found in above check, follow
procedure described in right col-
umn.
(12) Poor image transfer
Feeding direction