Filter
Top Products
TL-WR700N
150Mbps Wireless N Mini Pocket Router
- 6 -
On this mode, the only wired port works as WAN, which can be connected to DSL Modem with an
Ethernet cable. Computers could connect to the device by only wireless way.
Figure 2-1 Hardware Installation of the TL-WR700N in Router Mode
1. Connect the WAN port of TL-WR700N to the LAN Port on the DSL/Cable Modem.
2. Connect the WAN port on the DSL/Cable Modem to the wired Internet.
3. Plug the power plug of TL-WR700N in electrical wall socket.
4. Power on the DSL/Cable Modem, PC(s) and notebook(s).
Note:
The Device is equipped with a built-in DHCP server and it’s enabled by default. For your
convenience, please configure your PC or other clients to “Obtain an IP address automatically”. If
you need any instructions as how to do this, please refer to Appendix B: "Configuring the PC”
.
2.3.2 Repeater Mode
TL-WR700N is used to extend the range of wireless signal of the existing AP or wireless router.
On this mode, the only wired port works as LAN. Computer could connect to the device by either
wired or wireless way. The SSID of TL-WR700N should be the same as that of the device you
repeat.
Note:
The Device is equipped with Smart IP function, which would help to enable its built-in DHCP
server when it’s required. For your convenience, please configure your PC or other clients to
“Obtain an IP address automatically”. If you need any instructions as how to do this, please refer
to Appendix B: "Configuring the PC”
.