Filter
Top Products
K11020 VisionSensor™ 2030 User Manual, Rev. E, Software ver. 3.1.1000, August 3, 2007 - 10
Save Settings
If you are using the RS232 interface and utilizing Batch functionality, please read the Important Note
in batch section. If you are using the 1950 mAH battery for batch mode, the RS232 cable will recharge
the VS 2030 battery only if the RS232 cable has a power supply connected and the power supply is
plugged into a socket.
4. The VS 2030 will power on automatically.
5. Scan the RS232 One Way Mode code then the Save Settings code to congure reader:
RS232 One Way Mode Save Settings
6. Your VS 2030 unit should be ready for use. Open the application on your host computer that will
receive scanned data and begin scanning.
Warning: Videk, Inc.-approved power adapter must be used. Reader failure due to use of incorrect
power adapter will void all warranties.
1.6.3 - RS232 Cable Installation Guide
To connect the VS 2030 to your host computer via RS232 interface:
1. Make sure the RS232 cable is sufciently attached to your unit.
2. Connect the RS232 interface cable to your host computer. If you are unsure of the proper location to
connect the RS232 cable please consult the manual of your host computer.
RS232 Factory Default Settings
Mode: RS232 One Way Mode
Baud Rate: 57600
Stop Bits: 2
Data Bits: 8
Parity: None
3. The RS232 interface is supplied with a power supply. Plug the power supply adapter into the RS232
interface cable and then plug the power adapter into a wall socket.