5 - 16
No. 99MBC032A
• Measurement
PROG
BUSY
RUN
+NG
GO
-NG
The diagram at the right indicates that no workpiece is
present in the measuring region in the ready state.
PROG
BUSY
RUN
+NG
GO
-NG
Press the
C.RUN
key to start continuous measurement
while changing the display from “ ” to
“ .” If workpiece (a) enters the measur-
ing region, OD measurement will automatically be
started.
If the OD measurement resulting from 16 scans is
within the preset limits, a workpiece is judged as being
present (“workpiece present”). The system waits until
the specified invalidation period elapses.
PROG
BUSY
RUN
+NG
GO
-NG
After the invalidation period elapses, OD measurement
of workpiece (a) is started. At every measurement
interval the measured data will be displayed and the
GO/NG judgment results will be output.
PROG
BUSY
RUN
+NG
GO
-NG
Measurement of workpiece (b) entered.
As with workpiece (a) measurement is performed and
the results are displayed.
PROG
BUSY
RUN
+NG
GO
-NG
Workpieces that enter the measuring region are mea-
sured sequentially.
PROG
BUSY
RUN
+NG
GO
-NG
To terminate measurement, press the
RUN
key or
C.RUN
key again.
The most recently measured data will be displayed.
