9 - 3
No. 99MBC032A
9. RESTRICTIONS ASSOCIATED WITH THE COMBINATION OF FUNCTIONS, TABLES
OF THE BASIC SETUP MODES
9.2 List of Setup Modes
Tables in the following are the list of setup modes. Use these tables to check the setup data.
1. Make a check in the squares at the left of the mode number or in the setting content
column that need to be set up.
2. Fill in the setup values for the underlined part.
3. If these setup values are frequently changed, make copies of these forms.
9.2.1 List of basic setup modes
a: Resolution ( )
10
d. Method of average ( )
Mode No. Setup item Setup contents
Default setup
B1
B2
b: Number of blank-out digits
( )
c: Mark of thousandth digit ( )
a. Output in the ready state
( )
b. Message in the event of Err-0
( )
c. Message at the start of me
asurement ( )
e. Method of GO/NG judgment
( )
a. Workpiece type ( )
B0
b. Simultaneous measurement
( )
e. Display latch timer ( )
d: Buzzer sound ( )
Note: System error alarm
can not be prohibited.
c. Method of segment designation
( )
: No blank-out/ : 1 digit/ : 2 digits
: Does not output the GO/NG judgment
: Output the GO/NG judgment
: Displays “Err-0”.
: Displays “0”.
: Judges with the lower limit and upper limit
: Judges by multi-stage selection
: Judges with the target value + tolerance
f : Method of using the target value and reference value ( )
: Does not copy the target value on the reference value
: Copies the target value on the reference value
: Displays “-------”.
: Displays the previous data
: Arithmetic average / : Moving average
: 0/ : 1/ : 2/ : 3/
: 4/ : 5/ : 6/ : 7
: No mark/ : Mark
sec.
: Sounds at any event.
: Sounds when key input is made
(indicating acceptance or operation error).
: Sounds when a NG measurement results.
: Does not sound except a system error alarm.
: Opaque object
: Transparent object
: Single measurement
: Simultaneous measurement
: Segment specification
: Edge specification
( )
