2 - 5
No. 99MBC032A
2. SETUP
2.4 Initializing the LSM-9506
After making sure that this unit is operating normally, initialize the LSM-9506.
The initialization procedure is as follows:
Step 1: Turn off the power.
Step 2: Turn on the power while holding down the
C
key.
Hold down the
C
key for approximately 2 seconds, even after the power is on.
PROG
Step 3: When the self check has been completed, the
display shown at the right will appear. To initial-
ize, press the
ENT
key. When the initialization
process has been completed, the display restores
the initial conditions that existed just after the
power on.
To abort initialization press a key other than the
ENT
key or turn the power off.
In the former case the initialization process will be aborted and the initial display at
power-on will be restored.
IMPORTANT Initialization will clear all the customer setup data and will restore the factory-setups.
Customize the setups again as necessary.
