6 - 11
No. 99MBC032A
6. INTERFACE UNIT
6.1.7 Format of response commands
1) (DATA FORMAT): Data format (maximum 38 characters)
Pp, (GO/NG judgment result) ±ddd.dddd (, deviation)
a. Where the GO/NG judgment is active, GO/NG judgment result (-NG, OK or +NG) will
be appended.
b. Where the reference value is set, a deviation (, DEV±ddd.dddd) is appended.
This deviation value is derived from (Measured data - Reference value).
c. In the simultaneous measurement the foreground measurement is followed by the
background measurement after a comma (,) is inserted between them.
2) (RP FORMAT): Report format (maximum 107 characters)
PROGRAM, Pp, SG sssssss, Mm, LL ±ddd.dddd, LH ±ddd.dddd, REF ±ddd.dddd,
OF ±ddd.dddd, PR r, PRTttt, SMPnnn, AVG, ST
• A maximum of 107 characters will result from the above described specification, however,
it varies depending on the setup.
a. A maximum of 5 characters are to be added if the number of averages is specified.
b. A maximum of 8 characters are to be added if (target value + tolerance) is specified.
c. A maximum of 52 characters are to be added if the multi-stage selection is specified.
d. A maximum of 32 characters are to be added if the abnormal value eliminating function
is specified.
Between MM and LL “EL ±ddd.dddd, EH ±ddd.dddd” is inserted.
• Available symbols may change depending on the setup contents.
a. SG sssssss → SG aaa-bbb
b. Mm → Mnnnnn, Msm or MNHnnnn
c. LL ~ LH ±ddd.dddd → N ±ddd.dddd, LO ±ddd.dddd, UP ±ddd.dddd
→ L1 ±ddd.dddd, .................. , L6 ±ddd.dddd
e. OF ±ddd.dddd → OM ±ddd.dddd
f. AVG → MAX, MIN or RNG
g. ST → NST
3) (STAT FORMAT): Statistical data format (maximum 86 characters)
STAT DATA, Pp, Nnnnnnn, AVG±ddd.dddd, MAX±ddd.dddd, MIN±ddd.dddd,
RNGddd.dddd,S.Dddd.dddd
• “nnnnnn” implies the number of statistical data pieces, which is maximum 100,000. Data
pieces that exceed this limit will be excluded from the statistical data.
4) (RA FORMAT) : Data format for automatic workpiece detection (maximum 36 characters)
AUT, Nmmm, Dtttt, L±ddd.dddd, H±ddd.dddd
TIP 1. The integer section of “±ddd.dddd” will be zero-suppressed.
2. The “±” section will be “-” if the value is negative, and will be removed (the follow-
ing digits are left-flushed) if the value is positive.
