4 - 30
No. 99MBC032A
4) Setting the GO/NG judgment criteria (with “Target value + tolerance”)
In this example assume that the target value is 12.5 mm, lower tolerance is -0.01 mm, and
upper tolerance is 0.01 mm.
PROG
.5
12
PROG
Step 1: The previously set target value is displayed.
Enter “12.5”.
PROG
Step 2: Press the
ENT
key.
The setup data will be saved in memory and the
operation automatically proceeds to the lower
tolerance value setting.
The target value will be automatically copied on
the reference value if so set in the basic setup.
Step 3: Enter “0.01”, which is the lower tolerance value,
and a negative sign.
01
PROG
0
.
()
+/
-
PROG
PROG
Step 4: Press the
ENT
key.
The setup data will be saved in memory and the
operation automatically proceeds to the upper
tolerance value setting.
Step 5: Enter “0.01”, which is the upper tolerance value.
01
PROG
0
.
()
PROG
When copying the target value
to the reference value.
When not copying the target value
to the reference value.
PROG
Step 6: Press the
ENT
key.
The setup data will be saved in memory and the
operation automatically proceeds to the reference
value setting.
The displayed guidance for the setup item will
vary depending whether “Copying the target value
to the reference value” has been specified in the
basic setup.
