Filter
Top Products
26 Chapter4
Screens
Config screen
2. Slave address
The Slave address field appears only if you have selected HSCSD
Master as the instrument type and is the address used by the master
unit to send GPIB commands to the slave unit. This is only used when
the instrument is being operated manually.
NOTE You must ensure that the GPIB address on the slave unit matches the
value configured in the Slave address field on the master unit. The
GPIB address of the slave unit is set in the IO Config screen. However,
if you set the instrument type as HSCSD Slave, the GPIB address of the
slave is automatically set to 15 which is the default value of the Slave
address field on the master unit.
NOTE The default value is reset after a reset or power cycle. Note also that
changing the instrument type does not reset the value of this field.
Type integer
Units none (HP-IB address)
Limits 0 thru 30
Default 15