Filter
Top Products
Chapter 4 31
Screens
HSCSD screen
6. Call Type
The Call Type field determines which type of HSCSD call the HP/
Agilent 8922 establishes the next time a call is initiated.
If you select 2x1, the HP/Agilent 8922 tries to establish a call with 2
downlinks and 1 uplink when a call is next initiated. The measure
timeslot field will no longer be visible, nor will the controls concerned
with the second uplink (Slave TX level, Slave input level, Slave
input level control mode).
If you select 2x2, the HP/Agilent 8922 sets up a call with 2 downlinks
and 2 uplinks. The Measure timeslot field appears, along with controls
associated with the second uplink. The Measure timeslot field is set to
the default for each unit (slave for slave, master for master).
NOTE Each of these changes is subject to the conditions that a call must not be
in progress when the change to this field is made and that the field will
not change if changing the slave timeslot would make it take on an
illegal value.
Type Toggle
Units None
Default 2x2
Values 2x2 or 2x1