Filter
Top Products
Instruction book
2920 1521 00 54
4. Press the tabulator key (5): a screen similar to the one below will appear:
Service Timer
Level A
5000 hrs
↓
Menu Modify
F1 F2 F3
Fig. 8.17 Service plan menu
5. The screen indicates that the level for Service plan A is set at 5000 running hours.
6. Press the "Modify" key. The key "Limits" (F2) can be used to find the limitations for the parameter.
Use the ↓ or ↑ arrow key to modify the interval.
7. Press the key "Program" (F1) to program the new setting or the key "Cancel" (F3) to cancel the
modification operation.
8. The procedure to modify the Service plans B, D and I are carried out in a similar way. Press the ↓
key in Fig. 8.17 to find the other Service plans.
8.11 Programming Clock function
To program:
- time-based start/stop commands for the compressor
- time-based change-over commands for the net pressure band (see also section 8.8.1)
8.11.1 Programming start/stop/pressure band commands
In this example, the compressor will be programmed as follows:
- On Monday at 06:15 starting in pressure band 1
- On Friday at 18:00 changing over to pressure band 2
- On Saturday at 18:00 stopping
1. Starting from the Main screen (see section 8.1.2):
- press the key "Menu" (F1)
- press the ↓ key until the option "Modify parameters" is followed by a horizontal arrow
- press the tabulator key (5) to activate the menu
2. Use the ↓ key to scroll until the option "Clock function" is followed by a horizontal arrow. Press the
tabulator key (5), following screen appears:
Clock Function
Not activated
→
Menu Modify Delete
F1 F2 F3