Filter
Top Products
4-10
Cisco Personal Assistant 1.4 Installation and Administration Guide
OL-4590-03
Chapter 4 Configuring Personal Assistant
Specifying the Cisco CallManager Internal Directory Configuration (Personal Assistant Version 1.4(3) or Later)
Specifying the Cisco CallManager Internal Directory
Configuration (Personal
Assistant Version 1.4(3) or Later)
Personal Assistant uses the directory Cisco CallManager is using to maintain system configuration
information such as corporate directory settings and some user information such as call routing rules and
user recorded names. In a typical configuration, Cisco
CallManager uses its internal directory, DC
Directory. When Cisco
CallManager is in a cluster, Personal Assistant maintains information on the
publisher server. If Cisco
CallManager is using its internal directory, you can specify the directory
configuration to have Personal
Assistant read information from an available subscriber server in the
same cluster if the publisher is unavailable.
Note that because Personal Assistant can only read information from a subscriber server, it cannot
update configuration information unless the publisher is in service.
To specify the Cisco CallManager internal directory configuration, you identify the subscriber servers
in the Cisco
CallManager cluster.
Do the following procedure only if you are using Personal Assistant version 1.4(3) or later and if
Cisco
CallManager is using its internal directory.
To Specify the Cisco CallManager Internal Directory Configuration
Step 1 In the Personal Assistant Administration, select System > Cisco CallManager Directory. The
Cisco
CallManager Internal Directory Configuration page opens.
Step 2 In the Cisco CallManager Subscriber Server field, enter the host name or the IP address of the subscriber
server, and click Add.
Personal Assistant adds the server to the list of subscriber servers for the Cisco CallManager cluster.
Step 3 Repeat Step 2 for each subscriber server.
Step 4 Click Save to save and activate your changes.
Configuring Personal Assistant Servers
You must configure each Personal Assistant server to define its operating characteristics and to add it to
the server cluster.
To Configure Personal Assistant Servers
Step 1 In the Personal Assistant Administration, select Servers > Server Configuration. The Server
Configuration page opens.
This page has two columns:
• The left column lists the Personal Assistant servers you have already added to the Personal Assistant
server cluster. Click a server name to view and change the server properties. The primary
Personal
Assistant server is indicated by a red arrow.