Filter
Top Products
Model G0773 (Mfd. Since 12/14)
-27-
SECTION 4: LATHE OPERATIONS
Operation Overview
To complete a typical lathe operation, the
operator does the following:
1. Securely mounts workpiece in lathe.
2. Puts on safety glasses and a face shield, rolls
up sleeves, removes jewelry, and secures
any clothing, jewelry, or hair that could get
entangled in moving parts.
3. Installs tooling on toolpost, then backs it
away to establish a safe startup clearance.
4. Removes all setup tools from lathe.
5. Checks for safe clearances by rotating
workpiece by hand at least one full revolution.
6. Moves slides to where they will be used dur-
ing operation.
7. If using power feed, selects appropriate feed
rate and direction.
8. Sets spindle speed according to workpiece
size and material.
9. Starts spindle rotation and uses carriage
handwheels or power feed options to move
tooling into workpiece for operations.
10. When finished turning, rotates spindle direc-
tion switch to OFF, presses Emergency Stop
button, then removes workpiece.
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the
machine controls/components
discussed later
in this manual
are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual and
seek additional training from expe-
rienced
machine operators, and do additional
research outside of this manual by reading "how-
to" books, trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire manual BEFORE
using machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
To reduce risk of eye or face injury from
flying chips, always wear approved safety
glasses and face shield when operating this
machine.