Filter
Top Products
-4-
Model G0773 (Mfd. Since 12/14)
Controls &
Components
Refer to Figures 1–5 and the following descrip-
tions to become familiar with the basic controls of
this machine.
To reduce your risk of
serious injury, read this
entire manual BEFORE
using machine.
Headstock
F. Thread Dial: Indicates when to engage half
nut during threading operations.
G. 4-Way Tool Post: Holds up to four cutting
tools at once that can be individually indexed
to workpiece and quickly moved into position
when needed.
H. Compound Rest Handwheel: Moves tool
toward and away from workpiece at preset
compound angle.
I. Cross Slide Table: Supports compound
rest for lathe operations, and workpieces for
milling operations. Includes (2)
3
⁄8" T-slots
spaced 3.55" (90mm) on center, for mounting
milling vises or other fixtures.
J. Feed Selection Lever: Selects carriage or
cross slide for power feed.
K. Half Nut Lever: Engages/disengages half
nut for threading operations.
L. Cross Slide Handwheel: Moves cross slide
toward and away from workpiece.
M. Carriage Handwheel: Manually moves car-
riage left or right along bedway.
A. Lathe/Mill Selector Switch: Used to select
between lathe mode (1) or mill mode (2).
B. Spindle Direction Switch: Selects spindle
rotation direction.
C. Lathe Power Indicator Light: Illuminates
when Lathe/Mill Selector Switch is set to
lathe mode.
D. ON/OFF Switch w/Emergency Stop Button:
When pressed, cuts power to motor and con-
trol panel. To reset, press front tab, lift switch
cover, and press green ON button. Cover
must be unlatched for machine to run.
E. Gearbox Dials: Control rate of carriage
power feed, as indicated in threading and
feeding charts.
Figure 1. Headstock controls.
B
C
D
A
E
Carriage
Figure 2. Carriage controls.
L
M
G
H
I
J
K
F