Filter
Top Products
-40-
Model G0773 (Mfd. Since 12/14)
The cutting tool can be manually fed into the
workpiece using the carriage, cross slide, and
compound rest handwheels shown below.
Carriage Handwheel
Graduated Dial
Increments ...................................0.08" (2.03mm)
One Full Revolution ........................1.5" (38.1mm)
Use the carriage handwheel to move the carriage
left or right along the bed. Adjust the position of
the graduated scale by holding the handwheel
with one hand and turning the dial with the other.
Figure 48. Manual feeding controls.
Carriage
Handwheel
Manual Feed
Cross Slide
Handwheel
Compound
Rest
Handwheel
Cross Slide Handwheel
Graduated Dial
Increments ............................... 0.001" (0.025mm)
One Full Revolution .....................0.08" (2.03mm)
Use this handwheel to move the tool toward and
away from the work. The cross slide handwheel
has an indirect-read graduated dial, which shows
the actual distance the table moves.
Compound Rest Handwheel
Graduated Dial
Increments .............................. 0.001" (0.025mm)
One Full Revolution .....................0.08" (2.03mm)
Use this handwheel to move the cutting tool lin-
early along the set angle of the compound rest.
Set the compound rest angle by hand-rotating
it and securing it with the two cap screws (see
Figure 44 on Page 38). The compound rest has
an indirect-read graduated dial, which shows the
actual distance the tool moves.