Filter
Top Products
-6-
Model G0773 (Mfd. Since 12/14)
Milling Headstock
W. ON/OFF Switch w/Emergency Stop Button:
When pressed, cuts power to motor and con-
trol panel. To reset, press front tab, lift switch
cover, and press green ON button. Cover
must be unlatched for machine to run.
X. Mill Fault Light: Illuminates if mill motor is
overloaded.
Y. Fine Vertical Handwheel: Provides preci-
sion control of vertical headstock travel dur-
ing setups.
Z. Coarse Vertical Handwheel: Raises and
lowers headstock for Z-axis spindle position-
ing during setups.
AA. Vertical Travel Lock Lever: Locks head-
stock position along column.
AB. Mill Depth Stop: Limits downward move-
ment of mill headstock.
AC. Drill Chuck: Holds drill bit during milling
operations.
AD. Variable-Speed Spindle Control Dial:
Provides variable control of spindle speed
between 100–2500 RPM.
AE. Mill Power Indicator Light: Illuminates when
Lathe/Mill Selector Switch (see Page 4) is set
to milling mode.
Figure 5. Milling headstock controls.
AD
AE
AB
Y
Z
W
X
AA
AC