Filter
Top Products
-54-
Model G0773 (Mfd. Since 12/14)
Installing /Removing
To o l i n g
Cutting tools are sharp and
can easily cause cutting
injuries. Always protect
your hands with leather
gloves or shop rags when
handling cutting tools.
Installing Tooling
Tools Needed Qty
Wrench 17mm.................................................... 1
Spindle Locking Pin ........................................... 1
To install tooling:
1. DISCONNECT MACHINE FROM POWER!
2. Remove drawbar cap (see Figure 89).
Figure 89. Location of drawbar cap.
Drawbar Cap
3. Insert tooling (not included) into spindle until
in contacts drawbar.
4. Working from the top, thread drawbar by
hand into tooling until snug (see Figure 90).
Figure 90. Threading drawbar into tooling.
5. Insert spindle locking pin into hole in spindle,
and tighten drawbar, as shown in Figure 91.
Note: Do not overtighten drawbar.
Overtightening makes tool removal difficult
and may damage arbor and threads.
6. Re-install drawbar cap.
Figure 91. Tightening drawbar lock nut.
Spindle
Locking Pin