Filter
Top Products
-22- G0501 Sliding Table Saw
Moving & Placing
Saw Base Unit
To remove the saw base unit from the crate
pallet:
1. Cut off and remove all plastic straps from the
crate.
2. Position the forklift forks together and direct-
ly above the saw.
3. Place two lifting straps over the forks and
attach the ends to the lifting bolts as shown
in Figure 19.
Figure 20. Foot studs placed in base feet.
Figure 19. Lifting the saw base unit.
4. Lift the saw base unit and move it to your
predetermined location.
5. Before lowering the saw into position, place
safety blocks under the frame and thread the
four foot studs into the frame at least half of
their length.
6. Remove the safety blocks and lower the saw
onto the feet as shown in Figure 20 and
remove the forklift straps.
The Model G0501 is a
heavy machine that
weighs approximately
2300 lbs. Serious per-
sonal injury may occur if
safe moving methods
are not followed. To be
safe, you will need assis-
tance and power equip-
ment when moving the
shipping crate and
removing the machine
from the crate.
7. Place a level on the saw table and adjust foot
studs so the the saw table is level from left to
right and from front to back.
8. Lock the foot studs in position by tightening
their jam nuts against the machine body.